LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> F-150 FX2, 2D Pickup >> Repair and Diagnosis >> Brakes >> Parking Brake System - Parking Brake & Actuation >> Removal And Installation >> Parking Brake Control >> Removal

Parking Brake Control: Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. Remove the LH cowl side trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Release the tension on the parking brake cable. For additional information, refer to PARKING BRAKE CABLE TENSION RELEASE .
  3. Remove the parking brake release handle bolt and pull the handle assembly down to prevent breaking off the locator tabs.
  4. Disconnect the parking brake release handle cable from the parking brake control.
  5. Disconnect the parking brake switch electrical connector.
  6. Remove the 3 bolts from the parking brake control.
    • To install, tighten to 20 Nm (177 lb-in).
  7. Position the cable conduit grommet up through the floor.
    • Release the cable from the parking brake control.
  8. Remove the parking brake control from the vehicle.
scientia non olet · About LEMON Manuals