Adjustable Pedals Without Memory Feature

The adjustable pedals without memory are controlled by the brake pedal control switch and the Steering Column Control Module (SCCM). The adjustable pedals motor is attached to the accelerator pedal bracket and controls the accelerator pedals directly. It operates forward and rearward, depending on which direction the switch is pressed. The adjustable brake pedals is connected to the motor by a cable that rotates inside a sleeve. This allows both the brake and accelerator pedals to move together as an assembly. When the brake pedal control switch is pressed, voltage is applied from the SCCM  to the adjustable pedals motor. The end of the motor that is attached to the accelerator pedal bracket rotates the pinion of a worm gear set and causes the accelerator pedal to move. At the same time, the other end of the motor rotates the cable inside the sleeve which causes the brake pedal adjuster to move through the use of a worm gear set. The pedals can be adjusted with the ignition switch in the OFF, ACC or RUN position, regardless of gear selector position.

The SCCM  monitors the adjustable pedals motor and circuits for faults. If a fault is detected, the SCCM  is capable of setting DTCs.