Adjustable Pedals With Memory Feature

The adjustable pedals with memory are controlled by the SCCM  , Body Control Module (BCM) and Driver Seat Module (DSM). The pedals can be adjusted in 3 different ways:

• Using the brake pedal control switch.
• Using the memory SET switch.
• Using the Remote Keyless Entry (RKE) transmitter.

The SCCM  monitors the position of the pedals using a Hall-effect sensor that is integral to the adjustable pedals motor. When a memory position is recalled through either the memory SET switch or the RKE  transmitter, the SCCM  monitors the Hall-effect sensor and stops sending voltage to the motor once the commanded memory position is reached. If the SCCM  receives a pedals position input during a memory position recall function, the module stops the memory recall and responds to the new pedals position input.

When the RKE  transmitter is activated, a message is sent over the Medium Speed Controller Area Network (MS-CAN) to the DSM  . When the memory SET switch is pressed, the DSM  senses continuity to ground on the switch circuit. When the DSM  receives either the MS-CAN  message or the ground input through the switch circuit, it sends a message over the MS-CAN  to the BCM  . The BCM  acts as a gateway module, relaying the MS-CAN  message that was received from the DSM  to the SCCM  over the High Speed Controller Area Network (HS-CAN). The SCCM  then sends voltage over the appropriate circuit to the adjustable pedals motor to adjust the pedals.

The SCCM  continuously monitors the adjustable pedals motor and circuits for faults. If a fault is detected, the SCCM  is capable of setting DTCs.

The DSM  also controls the driver seat and the exterior mirrors.

For information on setting and recalling a memory pedal position, refer to Memory Position Programming in SEATING .