LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> F-150 FX2, 2D Pickup >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System Actuation >> Diagnosis And Testing >> Inspection And Verification >> Adjustable Pedals

Adjustable Pedals

  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART - WITHOUT MEMORY FEATURE

    Mechanical Electrical
    • Adjustable accelerator pedal and motor with cable attached
    • Adjustable brake pedal and bracket
    • Foreign objects or material
    • Wiring, terminals or connectors
    • Body Control Module (BCM) fuse(s):
      • 23 (15A)
      • 24 (15A)
    • Steering Column Control Module (SCCM)
    • Brake pedal control switch
    VISUAL INSPECTION CHART - WITH MEMORY FEATURE

    Mechanical Electrical
    • Adjustable accelerate pedal and motor with cable attached
    • Adjustable brake pedal and bracket
    • Foreign objects or material
    • BCM  fuse(s):
      • 23 (15A)
      • 24 (15A)
    • Memory SET switch
    • Remote Keyless Entry (RKE) transmitter
    • SCCM 
    • Wiring, terminals or connectors
    • Brake pedal control switch
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. NOTE: Make sure to use the latest scan tool software release.

    If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).

  5. NOTE: The Vehicle Communication Module (VCM) LED  prove out confirms power and ground from the DLC  are provided to the VCM  .

    If the scan tool does not communicate with the VCM  :

    • check the VCM  connection to the vehicle.
    • check the scan tool connection to the VCM  .
    • refer to MODULE COMMUNICATIONS NETWORK , No Power To The Scan Tool, to diagnose no power to the scan tool.
  6. If the scan tool does not communicate with the vehicle:
    • verify the ignition is ON.
    • verify the scan tool operation with a known good vehicle.
    • refer to MODULE COMMUNICATIONS NETWORK to diagnose no response from the PCM.
  7. Carry out the network test.
    • If the scan tool responds with no communication for one or more modules, refer to MODULE COMMUNICATIONS NETWORK .
    • If the network test passes, proceed with module self-test diagnostics.
  8. Carry out the self-test diagnostics for the SCCM  , BCM  and Driver Seat Module (DSM).
  9. If the DTCs retrieved are related to the concern, go to SCCM DTC CHART . For all other SCCM  DTCs, refer to STEERING COLUMN SWITCHES . For DSM  DTCs, refer to SEATING . For BCM  and all other DTCs, refer to MULTIFUNCTION ELECTRONIC MODULES .
  10. If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .
scientia non olet · About LEMON Manuals