Messaged Inputs

Module messaging is the standard for sending and receiving information required to operate the IPC  . All messages required for the IPC  to operate are received over the High Speed Controller Area Network (HS-CAN). For a list of module messages with the message origination sources, refer to MODULE COMMUNICATIONS NETWORK .

Listed below is a partial list of status and information messages that the IPC  requires from other vehicle inputs:

• ABS
  • ABS braking
  • Roll Stability Control (RSC®)
  • Traction control
• Base brake system
  • Brake fluid level status
  • Parking brake status
• Body
  • Door ajar
  • Supplemental Restraint System (SRS)
  • Tire Pressure Monitoring System (TPMS)
• Lighting system
  • LH/RH turn
  • High beam
• Powertrain
  • Charging system
  • ELD 
  • Engine emission system
  • Engine oil pressure
  • Engine RPM
  • Engine temperature
  • Four-Wheel Drive (4WD)
  • Tow haul status
  • Transmission range
  • Vehicle speed