Inspection and Verification
- Verify the customer concern.
- Visually inspect for obvious signs of electrical damage.VISUAL INSPECTION CHART
Electrical - Smart Junction Box (SJB) fuse 10 (15A)
- Wiring, terminals or connectors
- Illuminated components
- SJB
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
- NOTE:
Make sure to use the latest scan tool release software.
If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).
- NOTE:
The Vehicle Communication Module (VCM) prove-out confirms power and ground from the DLC are provided to the VCM.
If the scan tool does not communicate with the VCM:
- Check the VCM connection to the vehicle.
- Check the scan tool connection to the VCM.
- Refer to DIAGNOSIS AND TESTING , o Power To The Scan Tool, to diagnose no power to the scan tool.
- If the scan tool does not communicate with the vehicle:
- Verify the ignition key is in the ON position.
- Verify the scan tool operation with a known good vehicle.
- Refer to DIAGNOSIS AND TESTING to diagnose no response from the PCM.
- Carry out the network test.
- If the scan tool responds with no communication with the one or more modules, refer to DIAGNOSIS AND TESTING .
- If the network test passes, retrieve and record the continuous memory DTCs.
- Clear the continuous DTCs and carry out the self-test diagnostics for the SJB .
- If the DTCs retrieved are related to the concern, go to DTC CHARTS . For all other DTCs, refer to the Diagnostic Trouble Code (DTC) Chart in Diagnostic Trouble Code (DTC) Chart .
- If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .