Instrument Cluster Finish Panel - Navigator

NOTE: For information on Ford Color Coded Illustrations refer to COLOR-CODING - FORD .

Fig 1: Identifying Instrument Cluster Finish Panel Components - Navigator

Courtesy of FORD MOTOR CO.

Item	Part Number	Description
1	W707628	Steering column opening trim panel screws (3 required)
2	04459	Steering column opening trim panel
3	W707628	Instrument cluster finish panel screws (2 required)
4	04320	Instrument cluster finish panel

Lower the steering column to the lowest position.
Remove the 3 screws and the lower steering column cover.
- Disconnect the electrical connector for the brake pedal switch (if equipped).
Remove the 2 instrument cluster finish panel screws.
NOTE: There are 2 locking tabs on the outboard register that need to be depressed before the cluster finish panel is removed.
NOTE: Cluster finish panel removed for clarity.

Depress the 2 locking tabs and remove the cluster finish panel.
- Access the tabs from under the instrument panel.
- Disconnect the electrical connectors.
  
  Fig 2: Locating Cluster Finish Panel Locking Tabs
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Make sure to align the trim panel retaining clips to the retaining clip holes in the instrument panel.