LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2014 >> Escape S >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Cluster Illumination And Panel Illumination >> Diagnosis And Testing >> Instrument Panel Cluster (IPC) and Panel Illumination >> Pinpoint Tests >> The RH Front, RH Rear Or LH Rear Window Control Switch Illumination Is Inoperative Or Always On (With One-Touch Down Driver Window) >> Pinpoint Test G: The RH (Right-Hand) Front, RH (Right-Hand) Rear Or LH (Left-Hand) Rear Window Control Switch Illumination Is Inoperative Or Always On (With One-Touch Down Driver Window)

Pinpoint Test G: The RH (Right-Hand) Front, RH (Right-Hand) Rear Or LH (Left-Hand) Rear Window Control Switch Illumination Is Inoperative Or Always On (With One-Touch Down Driver Window)

  1. G1 VERIFY THE POWER WINDOW OPERATION 
    • Ignition ON.
    • Operate the power window from the suspect switch.

    Does the power window operate normally from the suspect switch? 

  2. G2 CHECK THE ILLUMINATION GROUND CIRCUIT AT THE WINDOW CONTROL SWITCH 
    • Ignition OFF.
    • Disconnect suspect window control switch.
    • Measure:

      RH Front Window Control Switch 

      Positive Lead Measurement/Action Negative Lead
      C643-4  OHM Ground

      RH Rear Window Control Switch 

      Positive Lead Measurement/Action Negative Lead
      C819-4  OHM Ground

      LH Rear Window Control Switch 

      Positive Lead Measurement/Action Negative Lead
      C717-4  OHM Ground

    Is the resistance less than 3 ohms? 

  3. G3 CHECK THE VOLTAGE SUPPLY CIRCUIT FOR A SHORT TO VOLTAGE AT THE WINDOW CONTROL SWITCH 
    • Ignition OFF.
    • Open and close the driver door to make sure that the delayed accessory power is off.
    • Disconnect suspect window control switch.
    • Measure:

      RH Front Window Control Switch 

      Positive Lead Measurement/Action Negative Lead
      C643-2  VOLTAGE Ground

      RH Rear Window Control Switch 

      Positive Lead Measurement/Action Negative Lead
      C819-2  VOLTAGE Ground

      LH Rear Window Control Switch 

      Positive Lead Measurement/Action Negative Lead
      C717-2  VOLTAGE Ground

    Is any voltage present? 

    • Yes  : REPAIR the circuit.
    • No  : The system is operating correctly at this time, CHECK the voltage supply circuit for an intermittent short to voltage.