LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Fusion Titanium, FWD >> Repair and Diagnosis >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center, And Warning Chimes (Except Hybrid) >> Diagnosis and Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> PINPOINT TEST AR: The Check Fuel Fill Inlet Message Is Always Displayed >> The Check Fuel Fill Inlet Message Is Always Displayed

The Check Fuel Fill Inlet Message Is Always Displayed

  1. AR1 CHECK THE MESSAGE CENTER OPERATION 
    • Ignition ON.
    • Close all doors the hood and luggage compartment lid.
    • Clear all message center warnings by pressing the OK button for each warning present.
    • Monitor the door ajar message center warning indicator.
    • Open the driver door.
    • Clear the message center pop-up warning.
    • Monitor the door ajar message center warning indicator.

    Is the door ajar message center warning indicator off with the door closed, and on with the door open? 

    1. Yes  :
    2. No  : INSTALL a new IPC  .

      REFER to: INSTRUMENT PANEL CLUSTER (IPC)  .

  2. AR2 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST 
    • Using a diagnostic scan tool, perform the IPC  self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    1. Yes  : REFER to DTC Chart: IPC .
    2. No  : GO to AR3 
  3. AR3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS) 
    • Using a diagnostic scan tool, check the GWM  Continuous Memory Diagnostic Trouble Codes (DTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    1. Yes  : REFER to: COMMUNICATIONS NETWORK .
    2. No  : If the check fuel fill inlet message is never on, the system is operating correctly at this time. There are currently no vehicle concerns present that require the check fuel fill inlet message display.

      If the check fuel fill inlet message is always on, DIAGNOSE all PCM  Diagnostic Trouble Codes (DTCs). Refer to the appropriate Engine Mechanical article for the procedure. Refer to ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) .