LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Fusion Titanium, FWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System And Stability Control (Except Hybrid) >> Diagnosis and Testing >> Anti-Lock Brake System (ABS) and Stability Control >> Pinpoint Tests >> Pinpoint Test P: U0104:00 >> U0104:00

Pinpoint Test P: U0104:00: U0104:00

  1. P1 CHECK THE COMMUNICATION NETWORK 
    • Ignition ON.
    • Using a diagnostic scan tool, carry out the Network Test.

    Does the CCM pass the Network Test? 

    1. Yes  : GO to P2 
    2. No  : DIAGNOSE the no communication with the CCM  concern.

      REFER to: COMMUNICATIONS NETWORK .

  2. P2 RECHECK THE ABS (ANTI-LOCK BRAKE SYSTEM) MODULE DIAGNOSTIC TROUBLE CODES (DTCS) 
    • Using a diagnostic scan tool, carry out the ABS  module self-test.
    • Clear the ABS  module Diagnostic Trouble Codes (DTCs).
    • Ignition OFF.
    • Ignition ON.
    • Using a diagnostic scan tool, carry out the ABS  module self-test.
    • Record the ABS  module Diagnostic Trouble Codes (DTCs).

    Is DTC U0104:00 retrieved again? 

    1. Yes  : GO to P3 
    2. No  : The system is operating correctly at this time. The DTC  may have been set due to high network traffic or an intermittent fault condition.
  3. P3 REVIEW THE RECORDED ABS (ANTI-LOCK BRAKE SYSTEM) MODULE DIAGNOSTIC TROUBLE CODES (DTCS) 
    • Review the previously recorded ABS  module Diagnostic Trouble Codes (DTCs).

    Was DTC U3003:16 or U3003:17 recorded? 

    1. Yes  : For DTC U3003:16,  GO to PINPOINT TEST A 

      For DTC  U3003:17, GO to PINPOINT TEST F 

    2. No  : GO to P4 
  4. P4 CHECK THE CCM (CRUISE CONTROL MODULE) FOR DIAGNOSTIC TROUBLE CODES (DTCS) 
    • Using a diagnostic scan tool, carry out the CCM  self-test.

    Are any battery voltage Diagnostic Trouble Codes (DTCs) present? 

    1. Yes  : REFER to: CRUISE CONTROL .
    2. No  : GO to P5 
  5. P5 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0104:00 SET IN OTHER MODULES 
    • Using a diagnostic scan tool, carry out the self-test for all modules.
    • Retrieve and record all Continuous Memory Diagnostic Trouble Codes (CMDTCs).

    Is DTC U0104:00 set in 1 or more modules in addition to the ABS module? 

    1. Yes  : CHECK OASIS  for any applicable Technical Service Bulletins (TSBs). If a TSB  exists for this concern, DISCONTINUE this test and FOLLOW the TSB  instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new CCM  .

      REFER to: CRUISE CONTROL MODULE (CCM) .

    2. No  : CHECK OASIS  for any applicable Technical Service Bulletins (TSBs). If a TSB  exists for this concern, DISCONTINUE this test and FOLLOW the TSB  instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new ABS  module and HCU  assembly.

      REFER to: HYDRAULIC CONTROL UNIT (HCU)  .

scientia non olet · About LEMON Manuals