LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Fusion Titanium, FWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System - Front (Except Hybrid) >> Diagnosis and Testing >> Front Seats >> Pinpoint Test(s) >> Pinpoint Test L: DTC: B1317 >> DTC: B1317

DTC: B1317

  1. L1 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) B1317, B1676 OR P0563 SET IN OTHER MODULES 
    • Ignition ON.
    • Using a diagnostic scan tool, retrieve the Continuous Memory Diagnostic Trouble Codes (CMDTCs) from all modules.

    Is DTC B1317, B1676 or P0563 set in more than one module? 

    1. Yes  : REFER to: CHARGING SYSTEM .
    2. No  : GO to L2 
  2. L2 CHECK THE BATTERY VOLTAGE 
    • Turn off all interior/exterior lights and accessories.
    • Start and run the engine at approximately 2, 000 rpm for 3 minutes while monitoring the battery voltage

    Does the battery voltage rise to 15 volts or higher? 

    1. Yes  : REFER to: CHARGING SYSTEM .
    2. No  : GO to L3 
  3. L3 RECHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) B1317 
    • Ignition OFF.
    • Ignition ON.
    • Using a diagnostic scan tool, clear the Continuous Memory Diagnostic Trouble Codes (CMDTCs).
    • Using a diagnostic scan tool, perform the DSM  self-test.

    Is DTC B1317 present? 

    1. Yes  : INSTALL a new DSM  .

      REFER to: DRIVER FRONT SEAT MODULE (DSM) .

    2. No  : The system is operating normally at this time. The DTC may have been set previously during battery charging or while jump starting the vehicle.
scientia non olet · About LEMON Manuals