Pinpoint Test P: U0140:00: U0140:00

P1 VERIFY THE CUSTOMER CONCERN
- Ignition ON.
- Verify there is an observable symptom present.
Is an observable symptom present?
- Yes : GO to P2
- No : The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
P2 CHECK THE COMMUNICATION NETWORK
- Ignition ON.
- Using a diagnostic scan tool, perform the network test.
Does the BCM pass the network test?
- Yes : GO to P4
- No : REFER to: COMMUNICATIONS NETWORK .
P3 PERFORM THE BCM (BODY CONTROL MODULE) SELF-TEST
- Using a diagnostic scan tool, perform the BCM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
- Yes : REFER to: BODY CONTROL MODULE (BCM) .
- No : GO to P4
P4 RECHECK THE PARKING AID MODULE (PAM) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a scan tool, clear the Diagnostic Trouble Codes (DTCs).
- Operate the system and test the system for normal operation.
- Check the Parking Aid Module (PAM) Continuous Memory Diagnostic Trouble Codes (CMDTCs).
Is DTC U0140:00 still present?
- Yes : GO to P5
- No : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
P5 CHECK FOR DIAGNOSTIC TROUBLE CODE (DTC) U0140:00 OR DIAGNOSTIC TROUBLE CODE (DTC) U0140:87 IN OTHER MODULES
- Using a diagnostic scan tool, clear all Diagnostic Trouble Codes (DTCs).
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Using a scan tool, retrieve the Continuous Memory Diagnostic Trouble Codes (CMDTCs) from all modules.
Is DTC U0140:00 or DTC U0140:87 set in any other module?
- Yes : INSTALL a new BCM .
  REFER to: BODY CONTROL MODULE (BCM) .
- No : INSTALL a new Parking Aid Module (PAM) (integral to the BCM ).
  REFER to: BODY CONTROL MODULE (BCM) .