Driver Side Rear Door Window Operation

The driver door window control switch communicates to the DDM  through a LIN  . The DDM  communicates to the RDM  through a LIN  .

When commanded by the driver door window control switch or the rear door window control switch, the RDM  supplies power and ground to operate the rear door window regulator motor in the desired direction. The RDM  monitors window glass position through feedback from 2 Hall-effect sensors (integral to the rear door window regulator motor). If there is an issue with the Hall-effect sensor circuit(s), the RDM  only moves the window in 500 ms intervals (the driver or rear door window control switch must be released and activated again to move the window).