Pinpoint Test Ad: U0208:00: U0208:00

AD1 VERIFY THE CUSTOMER CONCERN
- Ignition ON.
- Verify there is an observable symptom present.
Is an observable symptom present?
- Yes : GO to AD2
- No : The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
AD2 CHECK THE COMMUNICATION NETWORK
- Using a diagnostic scan tool, perform a network test.
Does the DSM pass the network test?
- Yes : GO to AD3
- No : REFER to: COMMUNICATIONS NETWORK .
AD3 CHECK FOR DSM (DRIVER FRONT SEAT MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, perform the DSM self-test.
Are any voltage related Diagnostic Trouble Codes (DTCs) present?
- Yes : REFER to: FRONT SEATS .
- No : GO to AD4
AD4 RECHECK THE DDM (DRIVER DOOR MODULE) OR PDM (PASSENGER DOOR MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during PMI or the PMI may not have been performed.
- Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs) and repeat the DDM /PDM self-test.
Is DTC U0208:00 still present?
- Yes : GO to AD5
- No : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
AD5 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0208 SET IN OTHER MODULES
- Using a diagnostic scan tool, clear all Diagnostic Trouble Codes (DTCs).
- Ignition OFF.
- Ignition ON.
- Wait 30 seconds.
- Using a diagnostic scan tool, retrieve the Continuous Memory Diagnostic Trouble Codes (CMDTCs) from all modules.
Is DTC U0208 set in other modules?
- Yes : INSTALL a new DSM .
  REFER to: DRIVER FRONT SEAT MODULE (DSM) .
- No : INSTALL a new DDM or PDM . For the DDM ,
  REFER to: DRIVER DOOR MODULE (DDM) .
  
  For a PDM ,
  
  REFER to: PASSENGER DOOR MODULE (PDM) .