LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Fusion Titanium, FWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Parking Aid System (Except Hybrid) >> Diagnosis and Testing >> Parking Aid >> Pinpoint Test(s) >> PINPOINT TEST Z: PINPOINT TEST Z: The Manual Zoom Feature Is Inoperative >> The Manual Zoom Feature Is Inoperative

The Manual Zoom Feature Is Inoperative

  1. Z1 PERFORM A NETWORK TEST 
    • Ignition ON.
    • Using a diagnostic scan tool, perform a network test.

    Do the BCM  , APIM  and FCDIM (if equipped) pass the network test? 

  2. Z2 CHECK FOR RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE BCM (BODY CONTROL MODULE) SELF-TEST 
    • Using a diagnostic scan tool, perform the BCM  self-test.

    Are any Diagnostic Trouble Codes present? 

    • Yes  : REFER to the BCM DTC CHART .
    • No  : If equipped with a 203 mm (8 in) touchscreen, GO to Z3 

      If not equipped with a 203 mm (8 in) touchscreen, GO to  Z4

  3. Z3 CHECK FOR RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE APIM (SYNC MODULE) SELF-TEST 
    • Using a diagnostic scan tool, perform the APIM  self-test.

    Are any Diagnostic Trouble Codes present? 

    • Yes  : Refer to the appropriate Information and Entertainment System - General Information for the procedure.
    • No  : GO to  Z5
  4. Z4 CHECK FOR RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE FCDIM (FRONT CONTROL/DISPLAY INTERFACE MODULE) SELF-TEST 
    • Using a diagnostic scan tool, perform the FCDIM  self-test.

    Are any Diagnostic Trouble Codes present? 

  5. Z5 CHECK FOR CORRECT VIDEO CAMERA OPERATION 
    • Ignition OFF.
    • Disconnect and inspect the rear video camera connector.
    • Repair:
      • corrosion (install new connector or terminals - clean module pins)
      • damaged or bent pins - install new terminals/pins
      • pushed-out pins - install new pins as necessary
    • Reconnect the rear video camera connector. Make sure it seats and latches correctly.
    • Operate the system and determine if the concern is still present.

    Is the concern still present? 

    • Yes  : CHECK OASIS  for any applicable Technical Service Bulletins (TSBs). If a Technical Service Bulletin (TSB) exists for this concern, DISCONTINUE this test and FOLLOW Technical Service Bulletin (TSB) instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new video camera.

      REFER to: PARKING AID CAMERA - VEHICLES WITH: 4-DOOR  .

    • No  : The system is operating correctly at this time. Concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.