Pinpoint Test AF: U0233:00: U0233:00

AF1 VERIFY THE CUSTOMER CONCERN
- Ignition ON.
- Verify there is an observable symptom present.
Is an observable symptom present?
- Yes : GO to AF2
- No : The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
AF2 CHECK THE COMMUNICATION NETWORK
- Using a diagnostic scan tool, perform a network test.
Does the SODR pass the network test?
- Yes : GO to AF3
- No : REFER to: COMMUNICATIONS NETWORK .
AF3 CHECK FOR SODR (SIDE OBSTACLE DETECTION CONTROL MODULE RH) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, perform the SODR self-test.
Are any voltage related Diagnostic Trouble Codes (DTCs) present?
- Yes : REFER to: BLIND SPOT MONITORING SYSTEM .
- No : GO to AF4
AF4 RECHECK THE PDM (PASSENGER DOOR MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during PMI or the PMI may not have been performed.
- Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs) and repeat the PDM self-test.
Is DTC U0233:00 still present?
- Yes : GO to AF5
- No : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
AF5 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0233 SET IN OTHER MODULES
- Using a diagnostic scan tool, clear all Diagnostic Trouble Codes (DTCs).
- Ignition OFF.
- Ignition ON.
- Wait 30 seconds.
- Using a diagnostic scan tool, retrieve the Continuous Memory Diagnostic Trouble Codes (CMDTCs) from all modules.
Is DTC U0233 set in other modules?
- Yes : INSTALL a new SODR .
  REFER to: SIDE OBSTACLE DETECTION CONTROL MODULE .
- No : INSTALL a new PDM .
  REFER to: PASSENGER DOOR MODULE (PDM) .