Power Door Locks

The BCM  controls the door locks by using a series of relays (driver door unlock/passenger doors unlock/all doors lock) integrated within it. When the relays are not energized, ground is provided on both circuits to the lock motors within the latches. When an unlock relay energizes, voltage is provided to one side of the lock motor to unlock the door(s). When the lock relay energizes, the polarity is reversed and the motors lock the doors.

The DDM  and PDM  send voltage signals to the door lock control switches. When a door lock control switch is pressed, the voltage signal is routed to ground, indicating a request to lock/unlock the doors. When the DDM  or the PDM  detects a lock or unlock request, a message is sent over the CAN  to the BCM  to lock or unlock the doors.

In the event of a power door lock failure, the doors can be individually locked through the manual door lock. The manual door lock is located on the rear edge of the door just above the door latch opening. For the doors on the left side of the vehicle, insert a key and turn clockwise to lock. For the doors on the right side of the vehicle, insert a key and turn counterclockwise to lock.

Based on input from the door lock control switches, the driver door lock cylinder, the keyless entry keypad, the passive entry system and the RKE  transmitter, the BCM  unlocks the driver door, unlocks all the doors or locks all the doors.