Brake Fluid Reservoir: Removal

NOTE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.

NOTE: Removal steps in this procedure may contain installation details.

Refer to: BRAKE MASTER CYLINDER .
Torque : 5.5 Nm
NOTE: Install new brake fluid reservoir seals. Lubricate the seals with clean, specified brake fluid.

Material : Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake Fluid/PM-20 (WSS-M6C65-A2) (ISO 4925 Class 6)