Pinpoint Test B: Outer Edge, Shoulder Wear

B1 MEASURE THE TREAD DEPTH
- Using a tread depth gauge or similar tool, measure the outside edge/shoulder tread depth.
Is the tread depth greater than 1.588 mm (0.0625 in)?
- Yes : ROTATE the wheel and tire assemblies.
  CHECK and ADJUST the toe to nominal -0.15 degrees (toe out). CHECK and ADJUST caster and camber to nominal.
  
  REFER to: FRONT CAMBER ADJUSTMENT - VEHICLES BUILT UP TO: 03-JUNE-2013 .
- No : INSTALL a new tire(s). CHECK and ADJUST the toe to nominal. CHECK and ADJUST caster and camber to nominal.
  REFER to: FRONT CAMBER ADJUSTMENT - VEHICLES BUILT UP TO: 03-JUNE-2013 .