Pinpoint Test AQ : The Adaptive Cruise Control Warning Chime Is Inoperative

WARNING: This page is about a different car, the 2015 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

AQ1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Unbuckle the driver safety belt.
- Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.
Does the safety belt warning chime operate for approximately 6 seconds?

Yes GO to AQ2

No Refer to IPC Hardware Testing .

AQ2 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes REFER to DTC Chart: IPC

No GO to AQ3

AQ3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes REFER to: COMMUNICATIONS NETWORK - 2.0L DURATEC - HYBRID (96KW 130PS)

No GO to AQ4

AQ4 CHECK THE CRUISE CONTROL DISPLAY IN THE MESSAGE CENTER
- Verify the adaptive cruise control display functions in the message center when the adaptive cruise control is in operation.
Does the cruise control display operate in the message center?

Yes DIAGNOSE the cruise control system. REFER to: CRUISE CONTROL

No GO to Pinpoint Test AB