LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Fusion Hybrid Titanium >> Repair and Diagnosis >> External Pages >> Different car >> Section 327 (Fuel Tank & Lines - 2.0L -- (Except Hybrid)) >> Removal And Installation >> Fuel Tank Filler Pipe >> Removal

Fuel Tank Filler Pipe: Removal

WARNING: This page is about a different car, the 2014 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation steps.
  1. WARNING: Before beginning any service procedure in this article, refer to Safety Warnings in GENERAL INFORMATION . Failure to follow this instruction may result in serious personal injury.

    Refer to: GASOLINE AND GASOLINE-ETHANOL FUEL SYSTEMS HEALTH AND SAFETY PRECAUTIONS .

  2. With the vehicle in NEUTRAL, position it on a hoist.

    Refer to: JACKING AND LIFTING - OVERVIEW .

  3. Disconnect the battery ground cable.

    Refer to: BATTERY DISCONNECT AND CONNECT .

  4. Drain the fuel tank.

    Refer to: FUEL TANK DRAINING .

  5. Remove the rear wheel on the left-hand side.

    Refer to: WHEEL AND TIRE .

  6. G08637756
  7. G08637757
  8. G09648145
  9. Refer to: QUICK RELEASE COUPLING .

    Torque  : 80 lb.in (9 Nm)

    G08637759
  10. Torque:  36 lb.in (4.1 Nm)
    G08637760