LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Fusion Hybrid Titanium >> Repair and Diagnosis >> External Pages >> Different car >> Section 233 (Parking Aid System - Active Park Assist -- (Except Hybrid)) >> General Procedures >> Elevation System Check >> Check

Elevation System Check: Check

WARNING: This page is about a different car, the 2014 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition ON, engine OFF.
    Fig 1: Identifying Elevation System Dimension
    G08056361Courtesy of FORD MOTOR CO.
  2. Set the parking brake.
  3. Place the gearshift in REVERSE (R) for rear parking aid sensors.
  4. Place the gearshift in DRIVE (D) for front parking aid sensors.
  5. Using a diagnostic scan tool, monitor the PAM  parking aid sensor distance Parameter Identifications (PIDs) to verify the PAM  detects no objects.
  6. If the audible warning is heard or if the Parameter Identifications (PIDs) indicate an object is detected, check to make sure the bumper is correctly installed and is not tilted downward so the sensor is pointing at the ground. Refer to DIAGNOSIS AND TESTING .
scientia non olet · About LEMON Manuals