DTC Chart: BCM
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices.
REFER to: DIAGNOSTIC METHODS .
| DTC | Description | Action |
|---|---|---|
| B1315:11 | Backlighting (Non Reflective Controls) Illumination Output: Circuit Short To Ground | GO to PINPOINT TEST B |
| B1315:15 | Backlighting (Non Reflective Controls) Illumination Output: Circuit Short To Battery Or Open | If all non-networked illumination sources are inoperative, GO to PINPOINT TEST B If all non-networked illumination sources are always on, GO to PINPOINT TEST D |
| B1436:01 | Digital Dimmer Switch Input: General Electrical Failure | GO to PINPOINT TEST A |
| U1000:00 | Solid State Driver Protection Activated - Driver Disabled: No Sub Type Information | The BCM has temporarily disabled an output because an excessive current draw exists (such as a short to ground). When this DTC is stored in the BCM , the illumination output driver (for non-networked illumination sources) is disabled until the cause of the excessive current draw has been corrected and a successful self-test has been performed. ADDRESS all other BCM Diagnostic Trouble Codes (DTCs) first. After the cause of the excessive current draw has been corrected, CLEAR the Diagnostic Trouble Codes (DTCs) and PERFORM the self-test. |
| U3000:49 | Control Module: Internal Electronic Failure | The BCM
has permanently disabled an output because an excessive current draw exists (such as a short to ground) that has exceeded the limits of what the BCM
can withstand. ADDRESS all other BCM
Diagnostic Trouble Codes (DTCs). After the cause of the excessive current draw has been corrected, INSTALL a new BCM
. REFER to: BODY CONTROL MODULE (BCM) . |
| All other BCM Diagnostic Trouble Codes (DTCs) | - | REFER to: BODY CONTROL MODULE (BCM) . |