Rear Toe Adjustment

SPECIAL TOOL(S) / GENERAL EQUIPMENT

Wheel Alignment System

Using alignment equipment and the manufacturer's instructions, measure the rear toe.
General Equipment : Wheel Alignment System

NOTE: The cam nut and cam bolt area must be free of foreign material to make sure of correct clamping.

NOTE: Clean the general area of the joint to prevent foreign material from entering the joint. Clean the area using only mild liquids.

NOTE: Jounce the vehicle to make sure that the suspension is in its normal, at-rest position.
On both sides.

Fig 1: Rotating Suspension Nut
Courtesy of FORD MOTOR CO.
On both sides.
Torque : 90 Nm

Fig 2: Locating Suspension Nut
Courtesy of FORD MOTOR CO.
Recheck the toe settings and adjust as necessary.