LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Focus Titanium, 4D Sedan, Standard Trans, Gas >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension - Except Electric >> Removal and Installation >> Spring >> Removal

Removal and Installation: Spring: Removal

    WARNING: Before beginning any service procedure in this service information, REFER to Safety Warnings in SERVICE INFORMATION General Information. Failure to follow this instruction may result in serious personal injury.
    NOTE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.
  1. Refer to: Health and Safety Precautions  ( HEALTH AND SAFETY PRECAUTIONS ).
  2. Refer to: WHEELS & TIRES .
  3. Discard the specified component. Follow local disposal regulations.
    Fig 1: Locating Lower Arm Fasteners
    G08055955Courtesy of FORD MOTOR CO.
  4. General Equipment  : Vehicle/Axle Stands
    Fig 2: Supporting Rear Suspension Using Vehicle/Axle Stands
    G08055953Courtesy of FORD MOTOR CO.
  5. Discard the specified component. Follow local disposal regulations.
    Fig 3: Identifying Suspension Bushing Disposal Fastener
    G08055957Courtesy of FORD MOTOR CO.
  6. Fig 4: Removing Spring Lower Arm
    G08055958Courtesy of FORD MOTOR CO.