LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Focus Titanium, 4D Sedan, Standard Trans, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 2.0L ECOBOOST) >> Removal and Installation >> Variable Valve Timing (VVT) Unit >> Installation

Variable Valve Timing (VVT) Unit: Installation

WARNING: This page is about a different variant/trim than selected.
  1. NOTE: Do not reuse the washers, new washers must be installed.
    Fig 1: Locating Camshaft Phaser And Sprocket Washers
    G08063210Courtesy of FORD MOTOR CO.
  2. NOTE: Do not tighten the bolts at this time. The bolts will be tightened during the timing drive component installation procedure.
    Fig 2: Locating Bolts Of Intake And Exhaust Camshaft Phaser And Sprockets
    G08062559Courtesy of FORD MOTOR CO.
  3. Refer to: Timing Drive Components  .
scientia non olet · About LEMON Manuals