Heated Oxygen Sensor (HO2S): Installation

WARNING: This page is about a different variant/trim than selected.

Calculate the correct torque wrench setting for the following torque. Refer to the Torque Wrench Adapter Formula in illustration .
Special Tool(s) : 303-476 (Socket, Exhaust Gas Oxygen Sensor)

Torque : 48 Nm

Fig 1: Installing Exhaust Gas Oxygen Sensor Using Special Tools
Courtesy of FORD MOTOR CO.

Fig 2: Torque Wrench Adapter Formulas
Courtesy of FORD MOTOR CO.
Fig 3: Locating Exhaust Gas Oxygen Sensor Connector And Clamp
Courtesy of FORD MOTOR CO.
Refer to: Battery Tray ( BATTERY TRAY ).