LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Focus Titanium, 4D Sedan, Standard Trans, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Electronic Engine Controls - 2.0L ECOBOOST) >> Removal and Installation >> Fuel Rail Pressure (FRP) Sensor >> Removal

Fuel Rail Pressure (FRP) Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
    WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in SERVICE INFORMATION General Information. Failure to follow this instruction may result in serious personal injury.
  1. Refer to: Health and Safety Precautions  ( HEALTH AND SAFETY PRECAUTIONS ).
  2. Refer to: Fuel System Pressure Release  ( FUEL SYSTEM PRESSURE RELEASE ).
  3. Refer to: Battery Disconnect and Connect  ( BATTERY DISCONNECT AND CONNECT ).
  4. Fig 1: Locating Fuel Rail Pressure (FRP) Sensor Connector
    G08063996Courtesy of FORD MOTOR CO.
  5. Fig 2: Identifying Fuel Rail Pressure (FRP) Sensor
    G08063997Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals