LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Focus Titanium, 4D Sedan, Standard Trans, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Electronic Engine Controls - 2.0L ECOBOOST) >> Removal and Installation >> Cylinder Head Temperature (CHT) Sensor >> Removal

Cylinder Head Temperature (CHT) Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.
    WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in SERVICE INFORMATION General Information. Failure to follow this instruction may result in serious personal injury.
  1. Refer to: Health and Safety Precautions  ( HEALTH AND SAFETY PRECAUTIONS ).
  2. Remove the air cleaner outlet pipe and the turbocharger inlet pipe. Refer to AIR CLEANER OUTLET PIPE .
  3. Fig 1: Removing Air Cleaner Outlet Pipe And Turbocharger Inlet Pipe
    G08063993Courtesy of FORD MOTOR CO.
  4. Discard the specified component. Follow local disposal regulations.

    Torque  : 10 Nm

    Fig 2: Removing Cylinder Head Temperature (CHT) Sensor
    G08063994Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals