LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Focus Titanium, 4D Sedan, Standard Trans, Gas >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation, Message Center, And Warning Chimes - Except Electric >> Diagnosis and Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> The Key-In-Ignition Warning Chime Is Inoperative (Without Intelligent Access [IA]) >> Pinpoint Test X: The Key-In-Ignition Warning Chime Is Inoperative (Without Intelligent Access [IA])

Pinpoint Test X: The Key-In-Ignition Warning Chime Is Inoperative (Without Intelligent Access [IA])

  1. X1: CHECK THE SAFETY BELT WARNING CHIME OPERATION 
    • Ignition OFF.
    • Ignition ON.
    • Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.

    Does the safety belt warning chime operate for approximately 6 seconds? 

    1. Yes:  GO to X2
    2. No:  GO to Pinpoint Test A 
  2. X2 CHECK THE INTERIOR LAMPS OPERATION 
    • Open and close the driver door.
    • Observe the interior lamps.

    Do the interior lamps operate correctly from the driver door? 

    1. Yes:  GO to X3
    2. No:  REFER to: INTERIOR LIGHTING .
  3. X3 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE BCM (BODY CONTROL MODULE) SELF-TEST 
    • Using a scan tool, perform the BCM self-test.

    Is DTC B10F1:13 present? 

    1. Yes:  GO to X4
    2. No:  GO to  X6
  4. X4 CHECK THE KEY-IN-IGNITION INPUT CIRCUIT FOR VOLTAGE 
    • Ignition OFF.
    • Insert the key into the ignition cylinder.
    • Disconnect: BCM C2280C.
    • Measure:

    Click to display connectors

    Positive Lead Measurement / Action Negative Lead
    C2280C-46
    G08065500
    		 -

    Is the voltage greater than 11 volts? 

    1. Yes:  GO to  X6
    2. No:  GO to X5
  5. X5 CHECK THE IGNITION SWITCH 
    • Ignition OFF.
    • Disconnect: Ignition Switch.
    • Carry out the ignition switch component test.

    Is the ignition switch OK? 

    1. Yes:  REPAIR the key-in-ignition input circuit.
    2. No:  INSTALL a new ignition switch.

      REFER to: IGNITION SWITCH .

  6. X6 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION 
    • Ignition OFF.
    • Disconnect and inspect all BCM connectors.
    • Repair:
      • corrosion (install new connector or terminals - clean module pins)
      • damaged or bent pins - install new terminals/pins
      • pushed-out pins - install new pins as necessary
    • Reconnect the BCM connectors. Make sure they seat and latch correctly.
    • Operate the system and verify the concern is still present

    Is the concern still present? 

    1. Yes:  CHECK On-Line Automotive Service Information System (OASIS) for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new BCM.

      REFER to: BODY CONTROL MODULE (BCM) .

    2. No:  The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.
scientia non olet · About LEMON Manuals