LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Focus ST >> Repair and Diagnosis >> External Pages >> Different car >> Section 712 (Engine Controls (Except Diesel & Hybrid) - Powertrain DTC Descriptions - DTC P1703 - P2A04, DTC PXXXX, DTC U0046 - U300C, DTC UXXXX) >> DTC P2195: O2 Sensor Signal Biased/Stuck Lean - Bank 1, Sensor 1

DTC P2195: O2 Sensor Signal Biased/Stuck Lean - Bank 1, Sensor 1

WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2012 Lincoln Navigator L, 2012 Lincoln Navigator, 2012 Lincoln MKZ, 2012 Lincoln MKX, and 2012 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.
P2195 - O2 SENSOR SIGNAL BIASED/STUCK LEAN - BANK 1, SENSOR 1

Description:  A heated oxygen sensor (HO2S) indicating lean at the end of a test is trying to correct for an over-rich condition. This DTC sets when the fuel control system no longer detects switching for a calibrated amount of time.
Possible Causes:  Electrical:
  • HO2S harness short to voltage
  • Water in the harness connector
  • HO2S circuit open
  • UO2SPC circuit open
  • Corrosion
  • Incorrect connections
  • Damaged HO2S
  • Damaged PCM

Fuel System:
  • Excessive fuel pressure
  • Leaking or contaminated fuel injectors
  • Leaking fuel pressure regulator
  • Low fuel pressure or running out of fuel

Evaporative Emission (EVAP) system:
  • EVAP purge valve stuck open

  • Air leaks after the mass airflow (MAF) sensor
  • Vacuum leaks
  • Positive crankcase ventilation (PCV) system is leaking or the valve is stuck open
  • Incorrectly seated engine oil dipstick

Exhaust Gas Recirculation (EGR) System:
  • Leaking gasket
  • Stuck EGR valve
  • Leaking diaphragm or EGR vacuum regulator

Base Engine:
  • Oil overfill
  • Camshaft timing
  • Cylinder compression
  • Exhaust leaks before or near the HO2S
Diagnostic Aids: 
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST H .