Removal and Installation: Turbocharger: Installation

NOTE: Make sure that the mating faces are clean and free of foreign material.

NOTE: Make sure that 4 new turbocharger-to-cylinder head studs, 4 new turbocharger nuts and a new turbocharger gasket are installed.
1. Torque : 50 Nm
Fig 1: Identifying Turbocharger-To-Cylinder Head Studs
Courtesy of FORD MOTOR CO.
NOTE: Only tighten the nuts finger tight at this stage.
1. Torque : 25 Nm
2. Torque : 24 Nm
Fig 2: Identifying Turbocharger Nuts
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.