LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Focus ST >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation, Message Center, And Warning Chimes - Except Electric >> Diagnosis and Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> U0200:00 >> Pinpoint Test Ar: U0200:00

Pinpoint Test Ar: U0200:00

  1. AR1 VERIFY THE CUSTOMER CONCERN 
    • Ignition ON.
    • Verify there is an observable symptom present.

    Is an observable symptom present? 

    1. Yes:  GO to AR2
    2. No:  The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  2. AR2 CHECK THE COMMUNICATION NETWORK 
    • Ignition ON.
    • Using a scan tool, perform the network test.

    Does the PDM pass the network test? 

    1. Yes:  GO to AR3
    2. No:  REFER to: COMMUNICATIONS NETWORK .
  3. AR3 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE PDM (PASSENGER DOOR MODULE) SELF-TEST 
    • Using a scan tool, retrieve the continuous memory Diagnostic Trouble Codes (DTCs) from the PDM.

    Is DTC U3003:62 recorded? 

    1. Yes:  REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS .
    2. No:  GO to AR4
  4. AR4 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST 
    • Using a scan tool, perform the IPC self-test.

    Are any DTC recorded? 

    1. Yes:  For DTC U3006:16, GO to Pinpoint Test AM 

      For DTC U3006:17, GO to Pinpoint Test AN 

    2. No:  GO to AR5
  5. AR5 RECHECK THE IPC (INSTRUMENT PANEL CLUSTER) DIAGNOSTIC TROUBLE CODES (DTCS) 
    NOTE: If new modules were installed prior to the DTC being set, the module configuration can be incorrectly set during the Programmable Module Installation (PMI) or the Programmable Module Installation (PMI) may not have been carried out.
    • Clear the Diagnostic Trouble Codes (DTCs).
    • Wait 10 seconds.
    • Using a scan tool, perform the IPC self-test.

    Is DTC U0200:00 still present? 

    1. Yes:  GO to AR6
    2. No:  The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  6. AR6 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0200:00 SET IN OTHER MODULES 
    • Clear all Diagnostic Trouble Codes (DTCs).
    • Ignition OFF.
    • Ignition ON.
    • Wait 10 seconds.
    • Using a scan tool, retrieve all continuous memory Diagnostic Trouble Codes (DTCs).

    Is DTC U0200:00 set in the BCM? 

    1. Yes:  INSTALL a new PDM.

      REFER to: DOOR MODULE .

    2. No:  INSTALL a new IPC.

      REFER to: Instrument Panel Cluster (IPC)  .

scientia non olet · About LEMON Manuals