LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Flex SEL, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation, Message Center, And Warning Chimes >> Removal And Installation >> Instrument Panel Cluster (IPC) >> Installation

Instrument Panel Cluster (IPC): Installation

  1. Position the IPC in the instrument panel, connect the electrical connector and install the 4 screws.
  2. Install the IPC finish panel. Refer to INSTRUMENT PANEL AND CONSOLE .
  3. If installing a new IPC, download the IPC configuration information from the scan tool into the new IPC. Refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
  4. NOTE: If a new IPC is installed, the IPC and the PCM require a parameter reset to allow the IPC and the PCM to recognize each other. Failure to carry out the parameter reset to the IPC and the PCM results in a no start condition.

    If installing a new IPC, carry out the parameter reset procedure. Refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS), WITHOUT INTELLIGENT ACCESS (IA) or ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS), WITH INTELLIGENT ACCESS (IA) .

  5. NOTE: The vehicle's Passive Anti-Theft System (PATS) keys must be programmed to the new IPC.

    If installing a new IPC, carry out the PATS key programming. Refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS), WITHOUT INTELLIGENT ACCESS (IA) or ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS), WITH INTELLIGENT ACCESS (IA) .

scientia non olet · About LEMON Manuals