LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Fiesta Titanium, 4D Hatchback, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation, Message Center & Warning Chimes >> General Procedures >> Belt-Minder® Deactivating/Activating >> Deactivating/Activating

Belt-Minder® Deactivating/Activating: Deactivating/Activating

  1. Turn the ignition switch to the RUN position (do not start the engine).
    • For vehicles with push-button start, push the start/stop switch and release quickly, do not attempt to start the engine.
  2. Wait approximately 1 minute until the safety belt warning indicator turns off.
  3. NOTE: Complete steps 3 and 4 within 30 seconds after the safety belt warning indicator turns off.
    NOTE: Buckle and unbuckle the safety belt at a moderate rate. If the safety belt buckle/unbuckle/buckle sequence is carried out too quickly, the Restraints Control Module (BCM) can fail to recognize one of the sequences and the procedure must be repeated.

    To disable the seating position, buckle then unbuckle the safety belt 3 times, ending in the unbuckled state.

    • After Step 3, the safety belt warning indicator illuminates for 3 seconds then turns off.
  4. Within 7 seconds of the indicator turning off, buckle then unbuckle the safety belt.
    • If currently enabled, this disables the Belt-Minder® feature for that seating position. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds.
    • If currently disabled, this enables the Belt-Minder® feature for that seating position. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds, followed by 3 seconds with the indicator off, then followed by the safety belt warning indicator flashing 1 time per second for 3 seconds.
scientia non olet · About LEMON Manuals