IPC Configuration
The IPC contains items that are configurable. Configurable items include customer preference items, which can be set with a scan tool. The remaining items can be set only through the Programmable Module Installation (PMI) procedure using As-Built data. Refer to MODULE CONFIGURATION SYSTEM .
NOTE:
When installing a new IPC, it is necessary to upload the module configuration to the scan tool. Following installation of the IPC download the module configuration from the scan tool into the new IPC. It is also necessary to carry out key programming and parameter reset whenever a new IPC or PCM is installed. Refer to ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM
.
IPC CONFIGURATION PARAMETERS
| Customer Preference | As-Built Parameter |
|---|---|
| - | Air bag driver side |
| - | Alarm |
| - | Alternator |
| - | Climate control unit |
| - | Cruise control |
| - | Emission standard |
| - | Engine type |
| - | Front center mounted display |
| - | Fuel |
| - | Gearbox |
| - | Gearbox type |
| - | Hill start assist |
| - | Integrated vehicle dynamic control |
| - | KVM (Intelligent Access (IA)) |
| - | Power steering type |
| - | Shift indication |
| - | Speedometer display |
| - | Speed warning device |
| - | Steering wheel position |
| - | Transmission driveline |
| - | Tire pressure mode system |
| - | Trip computer |
| - | Vehicle type |