DTC Charts: Notes
INSTRUMENT PANEL CLUSTER (IPC) DTC CHART
| DTC | Description | Action |
|---|---|---|
| B101E:01 | Air Conditioning Mode Switch: General Electrical Failure | REFER to HVAC - CLIMATE CONTROL SYSTEM - GENERAL INFORMATION AND DIAGNOSTICS . |
| B1029:11 | Accelerator Pedal Sensor: Circuit Short To Ground | FOLLOW the PCM diagnostics in ENGINE CONTROLS - SYMPTOM CHARTS (EXCEPT DIESEL & HYBRID) (SECTION 3) , Powertrain Control Module (PCM) Quick Test, of the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) . |
| B1029:13 | Accelerator Pedal Sensor: Circuit Open | FOLLOW the PCM diagnostics in ENGINE CONTROLS - SYMPTOM CHARTS (EXCEPT DIESEL & HYBRID) (SECTION 3) , Powertrain Control Module (PCM) Quick Test, of the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) . |
| B1048:01 | Brake Fluid Level Switch: General Electrical Failure | GO to PINPOINT TEST M . |
| B1053:11 | Fuel Tank Level Sensor: Circuit Short To Ground | GO to PINPOINT TEST B . |
| B1053:13 | Fuel Tank Level Sensor: Circuit Open | GO to PINPOINT TEST B . |
| B10BD:01 | Multifunctional Switch: General Electrical Failure | GO to PINPOINT TEST AE . |
| B10D5:94 | PATS Antenna: Unexpected Operation | REFER to ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM . |
| B10D7:05 | PATS Key: System Programming Failure | REFER to ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM . |
| B10D7:51 | PATS Key: Not Programmed | REFER to ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM . |
| B10D7:81 | PATS Key: Invalid Data Signal Received | REFER to ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM . |
| B10D7:87 | PATS Key: Missing Message | REFER to ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM . |
| B10D7:94 | PATS Key: Unexpected Operation | REFER to ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM . |
| B10D8:00 | PATS Key Less Than Minimum Programmed: No Sub Type Information | REFER to ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM . |
| B10DA:51 | PATS PCM Identifier: Not Programmed | REFER to ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM . |
| B10DA:62 | PATS PCM Identifier: Signal Compare Failure | REFER to ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM . |
| B1A14:11 | RCM Warning Lamp: Circuit Short To Ground | CLEAR the DTC. REPEAT the self-test. If DTC B1A14:11 returns, INSTALL a new Instrument Panel Cluster (IPC). REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation. |
| B1A14:13 | RCM Warning Lamp: Circuit Open | CLEAR the DTC. REPEAT the self-test. If DTC B1A14:13 returns, INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation. |
| B1A68:11 | Ambient Temperature Sensor: Circuit Short To Ground | GO to PINPOINT TEST AD . |
| B1A68:13 | Ambient Temperature Sensor: Circuit Open | GO to PINPOINT TEST AD . |
| B1A84:41 | Car Configuration Data: General Checksum Failure | CARRY OUT Programmable Module Installation (PMI) (when the original module is not available). REFER to MODULE CONFIGURATION SYSTEM . TEST the system for normal operation. |
| B1A84:51 | Car Configuration Data: Not Programmed | CARRY OUT PMI (when the original module is not available). REFER to MODULE CONFIGURATION SYSTEM . TEST the system for normal operation. |
| B1B71:11 | Evaporator Temperature Sensor: Circuit Short To Ground | REFER to HVAC - CLIMATE CONTROL SYSTEM - GENERAL INFORMATION AND DIAGNOSTICS . |
| B1B71:13 | Evaporator Temperature Sensor: Circuit Open | REFER to HVAC - CLIMATE CONTROL SYSTEM - GENERAL INFORMATION AND DIAGNOSTICS . |
| P0565:01 | Cruise Control ON Signal: General Electrical Failure | REFER to CRUISE CONTROL SYSTEM . |
| P0566:01 | Cruise Control OFF Signal: General Electrical Failure | REFER to CRUISE CONTROL SYSTEM . |
| P0567:01 | Cruise Control RESUME Signal: General Electrical Failure | REFER to CRUISE CONTROL SYSTEM . |
| P0568:01 | Cruise Control SET Signal: General Electrical Failure | REFER to CRUISE CONTROL SYSTEM . |
| P0569:01 | Cruise Control COAST Signal: General Electrical Failure | REFER to CRUISE CONTROL SYSTEM . |
| P0579:01 | Cruise Control Multi-Function Input A Circuit Range/Performance: General Electrical Failure | REFER to CRUISE CONTROL SYSTEM . |
| P0581:13 | Cruise Control Multi-Function Input A Circuit High: Circuit Open | REFER to CRUISE CONTROL SYSTEM . |
| P0704:01 | Clutch Switch Input Circuit: General Electrical Failure | REFER to CRUISE CONTROL SYSTEM . |
| P081C:01 | Park Input Circuit: General Electrical Failure | GO to PINPOINT TEST AG . |
| P1536:01 | Parking Brake Switch Circuit: General Electrical Failure | GO to PINPOINT TEST M . |
| P1572:01 | Brake Pedal Switch Circuit: General Electrical Failure | REFER to CRUISE CONTROL SYSTEM . |
| P1607:81 | MIL Output Circuit: Invalid Serial Data Received | DTC P1607:81 sets when the IPC receives invalid network data from the PCM. RETRIEVE and REPAIR all non-network DTCs in the PCM and other modules on the network. REFER to the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) and MULTIFUNCTION ELECTRONIC MODULES for navigation of all DTCs. TEST the system for normal operation. |
| P1607:87 | MIL Output Circuit: Missing Message | GO to PINPOINT TEST AM . |
| U0100:00 | Lost Communication With ECM/PCM "A": No Sub Type Information | GO to PINPOINT TEST AM . |
| U0101:00 | Lost Communication With TCM: No Sub Type Information | GO to PINPOINT TEST AN . |
| U0121:00 | Lost Communication With Anti-Lock Brake System (ABS) Control Module: No Sub Type Information | GO to PINPOINT TEST AO . |
| U0131:00 | Lost Communication With Power Steering Control Module: No Sub Type Information | GO to PINPOINT TEST AP . |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to PINPOINT TEST AQ . |
| U0151:00 | Lost Communication With Restraints Control Module: No Sub Type Information | GO to PINPOINT TEST AR . |
| U0214:00 | Lost Communication With Remote Function Actuation: No Sub Type Information | GO to PINPOINT TEST AS . |
| U0257:00 | Lost Communication With Front Controls/Display Interface Module: No Sub Type Information | GO to PINPOINT TEST AT . |
| U0401:68 | Invalid Data Received From ECM/PCM "A": Event Information | DTC U0401:68 sets when the IPC receives invalid network data from the PCM for the vehicle speed, engine rpm, engine temperature or odometer count input. RETRIEVE and REPAIR all non-network DTCs in the PCM and other modules on the network. REFER to the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) and MULTIFUNCTION ELECTRONIC MODULES for navigation of all DTCs. TEST the system for normal operation. |
| U0427:00 | Fault Received From External Node (this may display Invalid Data Received From Vehicle Security Module: Event Information) | DTC U2023 (U0427:68) sets when the IPC receives invalid network data from the Tire Pressure Monitor (TPM)/Vehicle Security Module (VSM) for the Tire Pressure Monitoring System (TPMS) input. RETRIEVE and REPAIR all non-network DTCs in the TPM/VSM and other modules on the network. REFER to WHEELS & TIRES for navigation of all DTCs. TEST the system for normal operation. |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | DTC U2101:00 sets when the IPC configuration does not match the configuration of the other vehicle modules. DETERMINE which module was recently installed and CARRY OUT Programmable Module Installation (PMI) (when the original module is not available) for that specific module. REFER to MODULE CONFIGURATION SYSTEM . TEST the system for normal operation. |
| U2104:01 | Trip Meter Reset Button: General Electrical Failure | CLEAR the DTC. REPEAT the self-test. If DTC U2104:01 is still present, INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation. |
| U3000:00 | Control Module: No Sub Type Information | CLEAR the DTC. REPEAT the self-test. If DTC U3000:00 returns, INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation. |
| U3006:16 | Control Module Input Power "A": Circuit Voltage Below | Threshold GO to PINPOINT TEST AU . |
| U3006:17 | Control Module Input Power "A": Circuit Voltage Above Threshold | GO to PINPOINT TEST AV . |
| U3010:01 | Ignition Input Start: General Electrical Failure | GO to PINPOINT TEST AW . |
PCM DTC CHART
| DTC | Description | Action |
|---|---|---|
| P0460 | Fuel Level Sensor A Circuit | REFER to the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) first. If sent here from the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) , GO to PINPOINT TEST B . |
| P0461 | Fuel Level Sensor A Circuit Range/Performance | REFER to the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) first. If sent here from the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) , GO to PINPOINT TEST B . |
| P0462 | Fuel Level Sensor A Circuit Low | REFER to the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) first. If sent here from the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) , GO to PINPOINT TEST B . |
| P0463 | Fuel Level Sensor A Circuit High | REFER to the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) first. If sent here from the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) , GO to PINPOINT TEST B . |
| All other DTCs | - | REFER to the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) . |
BODY CONTROL MODULE (BCM) DTC CHART
| DTC | Description | Action |
|---|---|---|
| B10F1:23 | Key In Switch: Signal Stuck Low | GO to PINPOINT TEST AI . |
| All other DTCs | - | REFER to MULTIFUNCTION ELECTRONIC MODULES . |