Symptom Chart

SYMPTOM CHART

Condition	Possible Sources	Action
The turn signal function is inoperative	Wiring, terminals or connectors Multifunction switch Body Control Module (BCM)	VERIFY the bulbs are OK. If OK, GO to Pinpoint Test K .
The turn signal function is always on	Wiring, terminals or connectors Multifunction switch BCM	GO to Pinpoint Test L .
NOTE: LED lamps draw low current compared to an incandescent bulb. The Smart Junction Box (SJB) interprets this as a bulb out and fast flashes (bulb outage mode) the turn lamps. The turn signal lamps fast flash and no bulbs are inoperative	Bulb(s)	INSTALL a correct bulbs as necessary. TEST the system for normal operation.
One turn signal/hazard lamp is inoperative/always on (4-door)	Wiring, terminals or connectors Bulb socket Turn relay BCM	VERIFY the bulb is OK. If OK, GO to Pinpoint Test M .
One turn signal/hazard lamp is inoperative/always on (5-door)	Wiring, terminals or connectors Bulb socket BCM	VERIFY the bulb is OK. If OK, GO to Pinpoint Test N .
The hazard lamp function is inoperative/always on	Wiring, terminals or connectors Front Controls Interface Module (FCIM) BCM	GO to Pinpoint Test O .