LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Fiesta Titanium, 4D Hatchback, Standard Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Warning Systems >> Instrumentation, Message Center & Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AS: DTC U0214:00 >> Pinpoint Test As: DTC U0214:00

Pinpoint Test As: DTC U0214:00

  1. AS1 VERIFY THE CUSTOMER CONCERN 
    • Ignition ON.
    • Verify that there is an observable symptom present.
    • Is an observable symptom present? 
    • Yes  : GO to AS2.
    • No  : The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  2. AS2 CHECK THE COMMUNICATION NETWORK 
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: Network Test.
    • Carry out the network test.
    • Does the RFA module pass the network test? 
  3. AS3 RETRIEVE THE RECORDED DTCs FROM THE RFA MODULE SELF-TEST 
    • Check for recorded DTCs from the RFA module self-test.
    • Is DTC U3003:16 or DTC U3003:17 recorded? 
  4. AS4 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST 
    • Check for recorded DTCs from the IPC self-test.
    • Is DTC U3006:16 or DTC U3006:17 recorded? 
  5. AS5 RECHECK THE IPC DTCs 
    NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI may not have been carried out.
    • Clear the DTCs. Repeat the IPC self-test.
    • Is DTC U0214:00 still present? 
    • Yes  : INSTALL a new RFA module. REFER to MULTIFUNCTION ELECTRONIC MODULES . CLEAR the DTCs. REPEAT the IPC self-test.
    • No  : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
scientia non olet · About LEMON Manuals