Pinpoint Test Ar: DTC U0151:00
- AR1 VERIFY THE CUSTOMER CONCERN
- Ignition ON.
- Verify there is an observable symptom present.
- Is an observable symptom present?
- Yes : GO to AR2.
- No : The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
- AR2 CHECK THE COMMUNICATION NETWORK
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
- Does the RCM pass the network test?
- Yes : GO to AR3.
- No : REFER to MODULE COMMUNICATIONS NETWORK .
- AR3 RETRIEVE THE RECORDED DTCs FROM THE RCM SELF-TEST
- Check for recorded DTCs from the RCM self-test.
- Is DTC U3003:16 or DTC U3003:17 recorded?
- Yes : REFER to SUPPLEMENTAL RESTRAINT SYSTEM .
- No : GO to AR4.
- AR4 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Check for recorded DTCs from the IPC self-test.
- Is DTC U3006:16 or DTC U3006:17 recorded?
- Yes
: For DTC U3006:16, GO to PINPOINT TEST AU .
For DTC U3006:17, GO to PINPOINT TEST AV .
- No : GO to AR5.
- AR5 RECHECK THE IPC DTCs
- Clear the DTCs.
- Wait 10 seconds.
- Repeat the IPC self-test.
- Is DTC U0151:00 still present?
- Yes : GO to AR6.
- No : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
- AR6 CHECK FOR DTC U0151:00 SET IN OTHER MODULES
- Clear all DTCs.
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Enter the following diagnostic mode on the scan tool: Self-Test.
- Retrieve the continuous memory DTCs from all modules.
- Is DTC U0151:00 set in the Occupant Classification System Module (OCSM)?
- Yes : INSTALL a new RCM. REFER to SUPPLEMENTAL RESTRAINT SYSTEM . CLEAR the DTCs. REPEAT the self-test.
- No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.