LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Fiesta Titanium, 4D Hatchback, Standard Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Warning Systems >> Instrumentation, Message Center & Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AM: DTC U0100:00 and P1607:87 >> Pinpoint Test Am: DTC U0100:00 And P1607:87

Pinpoint Test Am: DTC U0100:00 And P1607:87

  1. AM1 VERIFY THE SCAN TOOL CAN COMMUNICATE WITH THE PCM 
    • Connect the scan tool.
    • Check that a vehicle session can be established using the scan tool.
    • Can a vehicle session be established? 
  2. AM2 CHECK THE IPC CONTINUOUS MEMORY DTCs 
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: IPC Self-Test.
    • Clear the DTCs.
    • Wait 10 seconds.
    • Repeat the IPC self-test.
    • Is DTC U0100:00 or DTC P1607:87 retrieved again? 
    • Yes  : GO to AM3.
    • No  : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  3. AM3 RETRIEVE THE RECORDED DTCs FROM THE PCM KOEO SELF-TEST 
    • Check for recorded DTCs from the PCM Key ON Engine OFF (KOEO) self-test.
    • Is DTC P0562 or P0563 recorded? 
  4. AM4 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST 
    • Check for recorded DTCs from the IPC self-test.
    • Is DTC U3006:16 or DTC U3006:17 recorded? 
  5. AM5 CHECK FOR DTC U0100:00 SET IN OTHER MODULES 
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: Self-Test.
    • Retrieve the continuous memory DTCs from all modules.
    • Is DTC U0100:00 set in the Remote Function Actuator (RFA) module or the Restraints Control Module (RCM)? 
scientia non olet · About LEMON Manuals