Pinpoint Test Al: The Parking Brake Warning Chime Is Inoperative

AL1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN.
- Does the safety belt warning chime operate for approximately 6 seconds?
- Yes : GO to AL2.
- No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.
AL2 CHECK THE BRAKE WARNING INDICATOR OPERATION
- Apply the parking brake.
- Ignition ON.
- Observe the brake warning indicator.
- Does the brake warning indicator turn on?
- Yes : GO to AL3.
- No : GO to PINPOINT TEST L .
AL3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Check for recorded IPC DTCs from the self-test.
- Are any DTCs recorded?
- Yes : REFER to DTC CHART .
- No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.