LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Fiesta Titanium, 4D Hatchback, Standard Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seat System - Seats >> Removal And Installation >> Seat Latch Striker - Rear >> Removal and Installation

Removal and Installation

  1. Remove the lower C-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Remove the bolts and the backrest striker.
    • To install, tighten to 25 Nm (18 lb-ft).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals