Removal and Installation

From under the front of the cushion assembly, push the 2 seat cushion anchor latch release levers toward the driver side, while lifting up to disengage the front of the cushion assembly.

Fig 1: Pushing Seat Cushion Anchor Latch Release Levers Toward Driver Side
Courtesy of FORD MOTOR CO.
Remove the cushion assembly in the following sequence.
1. Push the cushion back as far as possible.
2. Lift up and pull forward at the rear outboard ends of the cushion, disengaging the wires from the retainer hooks.
  - Remove the cushion.

NOTE: Before installation, make sure the safety belts and buckles are accessible to the occupants.