LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Escape Titanium, AWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Rear Disc Brake System >> Removal And Installation >> Rear Brake Flexible Hose >> Removal

Rear Brake Flexible Hose: Removal

WARNING: Before beginning any service procedure in this information, refer to SAFETY WARNINGS in SERVICE INFORMATION . Failure to follow this instruction may result in serious personal injury.
NOTE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
NOTE: Removal steps in this procedure may contain installation details.
  1. Remove the wheel and tire. Refer to WHEELS AND TIRES .
    • To install, tighten the brake tube fitting to 15 Nm (133 lb-in).
    • To install, tighten the brake flexible hose bracket bolt to 11 Nm (97 lb-in).
      G08617164
    • To install, tighten to 32 Nm (24 lb-ft).
      G08617165