LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Escape Titanium, AWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System Actuation >> Removal And Installation >> Brake Master Cylinder >> Removal

Brake Master Cylinder: Removal

WARNING: Before beginning any service procedure in this information, refer to SAFETY WARNINGS in SERVICE INFORMATION . Failure to follow this instruction may result in serious personal injury.
NOTE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
NOTE: Steps in the removal procedure may include installation details.
  1. Remove the battery and battery tray. Refer to BATTERY, MOUNTING AND CABLES .
  2. G08611207
  3. G08611208
    • To install, tighten to 25 Nm (18 lb-ft).
      G08611209
    • To install, tighten to 18 Nm (159 lb-in).
      G08611210