LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Escape Titanium, AWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System Actuation >> Removal And Installation >> Brake Fluid Reservoir >> Removal

Brake Fluid Reservoir: Removal

WARNING: Before beginning any service procedure in this information, refer to SAFETY WARNINGS in SERVICE INFORMATION . Failure to follow this instruction may result in serious personal injury.
NOTE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
NOTE: Steps in the removal procedure may include installation details.

Remote brake fluid reservoir 

  1. Extract the fluid with a syringe.
    G08611207
  2. G08611208

    Brake master cylinder fluid reservoir 

  3. Remove the brake master cylinder. Refer to BRAKE MASTER CYLINDER .
  4. G08611213
  5. Discard the specified component. Follow local disposal regulations.
    G08611214

    Remote brake fluid reservoir 

    • To install, tighten to 2.5 Nm (22 lb-in).
      G08611215