Normal Operation and Fault Conditions - Sunshade

When the rear portion (OPEN) of the sunshade switch is pressed to the second detent position, a signal is sent to the sunshade motor through circuit CPR86 (GY/BN) which causes the sunshade to perform a one-touch open operation. When the front portion (CLOSE) of the sunshade switch is pressed to the second detent position, a signal is sent to the sunshade motor through circuit CPR85 (GN/WH) which causes the sunshade to perform a one-touch close operation. If the sunshade is closed or fully open and a one-touch operation is requested the sunshade will stop at the front of the fixed glass panel and a second one-touch request is necessary to fully open or close the sunshade. If the sunroof is open when the sunshade motor is commanded to perform a one-touch close operation the motors will communicate and the sunroof motor will automatically perform a one-touch close operation, then the sunroof motor will perform the one-touch close operation.

If the communication circuit between the sunroof motor and sunshade motor is open or shorted the sunroof motor will only fully close the sunroof one time, then not operate. Also, if the communication circuit is open or shorted the sunshade motor will open fully, then only operate between fully open and the front of the fixed glass panel.