Removal and Installation

NOTE: If installing a new Instrument Panel Cluster (IPC), it is necessary to upload the module configuration information to the scan tool prior to removing the IPC. This information must be downloaded into the new IPC after installation.

If installing a new Instrument Panel Cluster (IPC), upload the configuration information from the IPC module into the scan tool by following the scan tool on screen instructions.
- Record the odometer value from the original IPC. If the odometer value cannot be obtained from the IPC (display failure), perform the diagnostic routine. If the value cannot be obtained after the diagnostic routine, the customer should supply the approximate odometer value.
Lower the tilt steering column to the lowest position.
Pull the IPC finish panel straight out to release the retainer clips and remove the finish panel.
Remove the 2 IPC screws, pull rearward to release the rear retainers and remove the IPC.
- Disconnect the electrical connector.
- To install, tighten to 1.5 Nm (14 lb-in).
To install, reverse the removal procedure.
- If a new IPC had been installed, download the IPC configuration information from the scan tool to the new IPC by following the scan tool on-screen instructions.