LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Edge SEL, 2.0L Eng VIN 9 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.5L) >> In-Vehicle Repair >> Flexplate >> Installation

In-Vehicle Repair: Flexplate: Installation

WARNING: This page is about a different variant/trim than selected.
  1. NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.

    Install the flexplate and the 8 bolts.

    • Tighten in the sequence shown below to 80 Nm (59 lb-ft).
      G08976160
  2. Install the transaxle. For additional information, refer to AUTOMATIC TRANSMISSION - 6F50/6F55 .
  3. After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.
scientia non olet · About LEMON Manuals